Skip to main content Skip to search Skip to main navigation
Das Bild zeigt einen robusten, orangefarbenen Zurrgurt von Dolezych GmbH & Co. KG, ideal für sichere Transporte mit 50 mm Breite und 8.000 mm Länge.

Buy lashing straps and tension belts: ratchet straps for load securing

This category offers lashing straps and tension belts by Dolezych for load securing. Choose by lashing capacity, ratchet, hook and length. The main differences are explained below so you can quickly find the right strap.

Which strap fits? The ranges compared

Values are manufacturer data in daN (decanewtons) and can vary by version. The label on the strap is what counts. This page helps you choose and does not replace the operating manual or the calculation of your load securing.

RangeLCSTFNote
DoZurr 500250not statedfor example with dropside clamp
DoZurr 1000 with profile hook500150two-part
DoZurr 20001,000220two-part
DoZurr 5000 with push ratchet2,500300push ratchet
DoZurr 5000 with DoMulti pull ratchet2,500600long-lever pull ratchet
DoMatik 25350119automatic strap with S-hooks
DoMatik 351,000280automatic strap with profile hook

What do LC and STF on the label mean?

LC (lashing capacity) is the highest force the strap may take in a straight pull. It says nothing about how much weight it can secure. STF is the pre-tension the ratchet achieves at a defined hand force, for example 50 daN.

  • Tie-down lashing: The strap presses the load onto the loading area. STF is what counts here, and the strap needs an STF rating.
  • Direct lashing: The strap connects the load and the lashing point. LC is what counts here.
  • Lashing angle: For tie-down lashing, ideally close to 90°, never below 30° (German DGUV rule 114-615).

The number of straps your load needs cannot be stated in general terms. It depends on weight, friction and lashing angle, among other things.

Which ratchet is right?

  • Push ratchet: According to Dolezych, for light to medium applications.
  • DoMulti pull ratchet: Long-lever ratchet with 20 teeth and higher pre-tension. On the DoZurr 5000 this means 600 instead of 300 daN STF.
  • Automatic strap (DoMatik): A retraction function automatically pulls excess webbing back into the drum. The DoMatik 35 also has a stop mechanism. According to the manufacturer, the DoMatik 35 complies with EN 12195-2, while the DoMatik 25 is made along the lines of that standard.

Extensions on ratchets are not allowed, even if tensioning would then be easier.

Straps with hooks: which hook for what?

  • Profile hook: The common type, also available with a safety catch.
  • Finger profile hook: Can be attached with one hand.
  • Flat snap hook: With a safety latch.
  • Dropside clamp: According to Dolezych, it grips the top edge of the dropside and is intended for cases without lashing points on the loading area. This says nothing about whether your dropside can take the forces. Check this for your vehicle.
  • Single-stud fitting: For airline rails.

Frequently asked questions about lashing straps

Can I lift loads with a lashing strap?

No. Lashing straps are for load securing only. According to Dolezych, round slings or sling chains, for example, are suitable for lifting.

How often do lashing straps need inspecting?

German DGUV rule 114-615 states: check before each use, and have a competent person inspect and document at least once a year. According to the German BG BAU, the employer sets the type, scope and intervals, and it treats the annual inspection as proven practice.

When must a lashing strap be taken out of service?

If the label is missing or illegible, the strap must not be used. Other reasons include damage to load-bearing seams, deformation from heat, damage from aggressive substances and damaged fittings. Sources differ on the 10 % limit for the webbing: BG BAU names yarn breaks and cuts of more than 10 % of the cross-section in the fabric, BG ETEM cuts over 10 % at the woven edge, and Dolezych damage to more than 10 % of the webbing cross-section. If in doubt, stop using the strap.

Do lashing straps have an expiry date?

According to Dolezych, there is no general expiry date, provided the straps are stored protected from the weather. Instead, the manufacturer names a visual check before each use and an annual inspection by a competent person. Straps that have reached their discard limit must not be used any further.

Which standard applies to lashing straps?

DIN EN 12195-2 applies to lashing straps made of man-made fibres. Whether a strap is made to this standard is shown on the label.

Matching accessories

Sharp edges damage webbing, which is what edge protectors and edge protection angles are for. Anti-slip mats add friction.

Not sure which strap fits? Call us: +49 2237 628095-00, Monday to Friday, 9 am to 5 pm. Our information does not replace calculating load securing for the individual case.